GANTRY CRANES

1. GANTRY CRANES FOR GENERAL APPLICATION


BASIC INFO

The gantry cranes for general application are designed and produced according to EN standards and are used for manipulation of various loads.

The mechanism for lifting can have a hook, electromagnet or hydraulic grabber, depending on the type of load that is manipulated.

The crane governing is done from the cab, which is moving as well as the trolley that provides a good visibility or using a radio remote controls.

The crane structure consist of portal frame, made of steel sheets, with the permanent radiographic control during the production process. All the basic structural elements are detachable, which makes an easier transport and assembly.

For heavy operating conditions, the driving mechanisms are in standard design, according to corresponding crane driving class, while for easier operational regimes, the compact driving sets are applied.

The electrical equipment is installed on the accessible place that provides an easier maintenance.

During the takeover of the crane, attest and other technical documentation are supplied according to the applicable regulations.

  • GANTRY CRANES FOR GENERAL APPLICATION

2. GANTRY CRANES FOR WOOD INDUSTRY


BASIC INFO

The gantry cranes for wood industry are designed and produced according to EN standards and are used for manipulation of logs in open warehouses. On the lifting unit there is a slewing hydraulic grab enabling caching, lifting and transfering of logs without the help from the ground.

The crane governing is done from the cab placed on the movable trolley that provides a good visibility or using a radio remote controls

The crane structure consist of the following:

  1. main girder – crane bridge, designed as a pipe lattice steel structure of triangular cross section;
  2. portal frame, aslo designed as a pipe lattice steel structure;
  3. travelling supports, made of steel rolled and sheet sections.

 

All the basic elements are detachable, which makes an easier transportation and assembly.
The crane is supported on eight wheels of which two or four are drives. The drives are designed and produced by III driving class.

During the takeover of the crane, attest and other technical documentation are supplied according to the applicable regulations.

 

  • GANTRY CRANES FOR WOOD INDUSTRY
  • GANTRY CRANES FOR WOOD INDUSTRY
  • GANTRY CRANES FOR WOOD INDUSTRY

3. GANTRY CRANES FOR CONTAINER RELOADING


BASIC INFO

The gantry cranes for container reloading are designed and produced according to EN standards and are used for reloading of containers of all types and sizes.

The crane governing is done from the cab placed on the movable trolley that provides a good visibility or using a radio remote controls

The crane structure consist of the following:

  1. portal frame, made of steel sheets and steel girders wich are welded during the production process with a permanent radiographic control;
  2. load lifting device ( slip regulator - ring motor, brake calliper, reduction gear and drum);
  3. device for trolley driving;
  4. hydraulic grabber for containers.

All the basic elements are detachable, which makes an easier transportation and assembly.
During the takeover of the crane, attest and other technical documentation are supplied according to the applicable regulations.

 

  • GANTRY CRANES FOR CONTAINER RELOADING
  • GANTRY CRANES FOR CONTAINER RELOADING
  • GANTRY CRANES FOR CONTAINER RELOADING

downloadCatalogue: Industrial Cranes in .pdf form